Hi,

I cannot get my HiLo to lower. It will lower about half way down and then stop. I do not see any obstructions. It has been in the up position for quite a while. What could be the problem?

Also, I need a new fresh water tank. My tank has rusted through. Any suggestion on where to get a new tank?

Thanks so much!

Something must be binding if you can't lower it. Have you inspected the guide blocks that follow the rails on the lower half? Is the guide rod underneath lubricated, not bent and clean? Is the top half level when it is raised? Is the trailer leveled? Is the bottom half distorted?

I thought all the tanks were plastic. You should be able to get a new plastic one from most any RV supply company. Here's a link to some at Camping World: Replacement Tanks - Product - Camping World, but I'd shop around.

- Jack

__________________
Hi-Lo 1707T - Tire Minder TPMS on Tow Vehicle and Trailer, 300W Solar Battery Charger, Equal-i-zer WDH, Progressive Dynamics Converter, Fan-Tastic Fan, LiFePO4 battery 12V DC Electrical System, SoftStartRV mounted on A/C
2024 F150 Platinum FX4 3.5L PowerBoost SCrew

Not sure where your located at, Look at RV salvage yards(do a google search) .I know of one ;RV doctor in sacramento,CA. Take the old tank with you to match it.

__________________
Les & Patricia
2006 22ft towlite (replaces 97 21TL)
2006 Toyota tacoma pre-runner 4.0 L V-6 quad cab
w/ 98 chevy Powervision towing mirrors
2017 Chevy Silverado 1500 5.3 v8 (replaces Toyota)
2 Hobie mirage pedal drive kayaks

Jack,

Thanks so much. I have checked everything, but still no luck. I have just replaced the solenoid switch and wonder if that could be the problem. Also, my water tank is a round metal tank in a '77 - 22 ft. HiLo. I have not been able to locate one, but would like to replace with a plastic one. Again, thanks.

Can you tell where it's "hanging up"? I can't imagine how the solenoid switch would be the problem if it moves down part way. It sounds to me like something is physically "catching" the top on the way down.

I think as far as your water tank is concerned, it would be best to get the old one out as campthewest suggested, then try to match the shape and size if only a round one will fit. The one in my trailer is rectangular.

Good luck on this!

- Jack

Have you tried lowering the top using the manual lowering valve on the hydraulic pump? If you open this valve and the top still hangs up then you have ruled out the solenoid valve as the problem. Does the top hang up in the same spot each time? As Jack indicated make sure the guide rod on the Hyd cylinder is clean, not bent and lubed. Raise the top and inspect all of the lifting cables to see if one has a bunch of wire strands broken and bunched up and then hanging up on a pulley and pulley guide. Look for a broken pulley. Let us know what you find. Good luck.

__________________
Jim L & Faye
2805C
2003 Silvarado diesel crew cab
2017 Silvarado, crew cab 1500 6.2L gas w/ 8 speed tranny
central VA