Quote:
Originally Posted by raagee
I have recently purchased an 2902BX...When looking at the lifting cable attachment points on the bottom side of the top, the cables have actually cut into the inner edge. On the LR cable, the aluminum box channel (inside the wall) as actually bent due to excessive lifting force. I discovered this while conducting delamination repairs. To rectify this issue, I have had C channels made from 1/8" steel (then powder coated) to assist in spreading the lifting force to more of the upper frame. (Why Hi-Lo put windows above lifting points is beyond me). Has anyone else seen this type of failure?
|
Yes, I had it on my trailer, but it was all my fault. I adjusted one corner of the top too high, thinking I needed to align the edges of the molding on the bottom half and the top half on the inside of the trailer. So, I shortened that cable too much, which bent the edge guard that the cable went around along the bottom edge of that corner.
I did something like you did to fix it. First, I filled the dent along the bottom edge with epoxy, then I cut and applied a longer aluminum edge guard under the straightened OEM guard. And, I carefully adjusted all cables so that the rubber gasket along the inside of the top just touches the "lip" along the top edge of the bottom half.
I have a post in a thread from several years ago with pictures to show my repair. It's Post #5 here:
http://www.hilotrailerforum.com/f17/...l-height-1632/
- Jack
__________________
Linear Mode
