Quote:
Originally Posted by Garry
Moonstruck, In what way did you rebuild the bed platform?...reinforcement?
|
I'm not certain the platform in the trailer was even the stock arrangement. It had an inner spring mattress that looked like stock, but it was totally unsatisfactory. Also, when towing from Ocala to Tennessee the mattress was moving around all out of place.
I used nominal 3/4" plywood to build the platform. Duct tape was used on all joints and screw heads to keep from snagging the mattress. After cutting and radiusing the corners duct tape was used around the edges to give a better edge. I ordered a 16" adjustable retainer bar from an adjustable bed place. This keeps it from sliding forward off the platform. I then basically covered the platform with some rubber matting that should hold the mattress in place.
http://www.adjustablebedmart.com/retainerbars.html
Of course fitted bedding for an RV short queen is not stock. So we ordered a couple of sets of 600 count sheets and a duvet cover and shams. Picked up a couple of lamps. We will probably re-wall paper later. We are doing a few more mods along the way.