We found out the hard way that the supports for the bed/table in our 2506C
were minimal at best. Bought some angle aluminum at Home Depot, did a little
filling to round the corners and added some pads, to give some added support. So we don't end up on the floor!

Attached Images

hi lo alts 011.jpg (89.3 KB, 155 views)

__________________
2506C
2009 F-250 Crew Cab SD

Your Idea is a good one! At 6'4" and 260#'s, I rode our table/bed to the floor one night. Since it's just my wife and I and the dog, the dinette bed is now happily claimed by our American Bulldog. Our loss is her gain!

We also had to bulk up our table/bed like you did, in addition we added quiet a bit on the bottom of the table top. It doesn't show from the top, but is much more sturdy now.