Search results

Aluminum frame Even if it has an aluminum frame, there is a heavy wood piece where the cable attaches at all 4 places. J&R repair in Ohio replaced the roof and the 4 lifting pieces of wood and a lot of other repairs on our 2510 it was damaged by hail and not open up until several weeks later...

My 2510 Hi Lo was totaled by hail damage, unknow to me, several weeks had past. When I opened it up water damage was bad and black mold was everywhere. The roof had breaks in the aluminum everywhere and the air conditioner cover had holes in it. The awning was damaged also. The insurance company...

That is a common part and can be got at an RV store

Mine has an air mattress and it is a rather close to get past. Has to be made into a couch in the day time.

Mine has speakers on both sides of the front window behind the window shade.

Thank you all for your kind thoughts and prayers. It was and accident that happened at home when I wasn't there.

Mary passed away on 4-12-14. I am at a total loss, so my presence at the forum will be on hold for some time.

Not the same company. Hi-Lo trailers were manufactured in Ohio by the HI-Lo Company.

At this point I would say someone connected the fuse panel in side directly to the black wire from the battery that goes to the converter or they ran a new wire from the battery to the fuse panel.

Maybe the previous owner put a different switch on it.

I would say your battery is good, as the lift motor draws at least 80 amps, It is an auto type starter motor, there is a break in the current to the inside of the trailer, check inside the battery area for a 12 volt auto type circuit breaker as it may be tripped, there is a little reset button...

Looking back at motobuffy's post the 2 small wires with the red tracer which come from the battery should be connected to the 2 center terminals on the switch and the 2 small red wires should be connected to the 2 bottom terminals on the switch. Only 1 top terminal is used and either one should...

Yes, I forgot to add that, both sides of the switch share the load this the reason for the smaller wires. Also center position is off no power supplied to top or bottom terminals.

Just looked at my 2209, here is the way it is wired. Positive from the battery comes in thru a heavy red wire which is then reduced to 2 smaller wires, each of these are connected to the master switch 2 center terminals. There is 2 small wires connected to the bottom 2 terminals and these are...

If you still have the 2506 that you listed before it has an aluminum frame. It is thin wall aluminum so go from there. You didn't say where at on the frame? A picture would help.

Can you post some pictures of the new pump and the pluming. When you say the old pump wasn't working. Was the motor running? Or you just thought it was the motor?

Yeh, I have done the same thing, doesn't seem like gray water would hurt anything.

My experience is that most all camp grounds do not allow the discharge of gray water. Actually never found one that did. Yet tent campers do it all the time.

First you should never tow a Hi-Lo with the top up as damage to the cable system can result. To get it off the safety bar, push the button and raise the top a little, the pump will make noise this is normal, now pull the safety release cable and hold it out, at the same time push the button for...

I didn't know for sure but knew it would hold 250

The drop down bed will support him they are rated at 250 lbs. You just have to provide a way of getting up on the bed.

I assumed that he described the noise wrong, but if it was a grinding noise something is definitely wrong.

This is the first winter in a lot of years that we didn't go south and it had to be one of the worst winters in a long time. So I feel your pain. Mary had pneumonia and I have to go to physical therapy, both of us are longing for warmer weather. It does seem to be breaking some, hope it...

Check the hydraulic fluid in the pump tank, the level should be within 1 inch of the top with the trailer top down. Do not fill with the trailer top up, it will be over filled and when the top comes down it could damage the plastic tank besides being all over the ground. Use dextron transmission...

Battery power to the panel comes thru the master switch and only works with the master switch in the right position, which is opposite the position for top up and down. To check the converter plug into 110 shore power make sure there is 110 at the outlets inside then put a volt meter on the...