Search results

  1. pcorbin

    Fix for cracked shower pan?

    That's exactly what I was looking for, and found a local source - thanks!
  2. pcorbin

    Fix for cracked shower pan?

    We have never used the shower since we have had our Towlite 187TD, because it a) is so small I barely fit inside (it's a Thetford toilet/shower combo) and b) the floor is cracked a few inches from the drain. No missing pieces, but cracked. Instead of replacing the entire pan (I think I saw one...
  3. pcorbin

    Question on towing while slightly raised

    That's a good idea - it won't be serving any purpose anyway, and I can lower the top completely without interference that way. I guess I could also find/make something to put back there that may help it seal - something about 1/4" thinner than the original bottom plastic seal. Our's has no side...
  4. pcorbin

    Question on towing while slightly raised

    Due to the way we rebuilt a side wall on our 1807TD Towlite (100% rebuild, from scratch) we are off on the bottom rail where it should pass over the bottom seal on the camper bottom half (as the top is at it's lowered position) by juuuusstttt enough to make it rub/hang up when lowering and...
  5. pcorbin

    How to get guide block to "down" position

    Thanks to all for help! We were able to get the guide bar into position with the help of a come-along. All went well, camper is operational. :)
  6. pcorbin

    How to get guide block to "down" position

    For #2 - wouldn't I need to have someone apply tension to the cables after disconnected from the top (same as if from bottom), as it is raised?
  7. pcorbin

    How to get guide block to "down" position

    I sure did use that extensively - thanks! This is the tail end of a complete side wall rebuild, and your doc helped a lot!
  8. pcorbin

    How to get guide block to "down" position

    Thank you for your help - I have 2 farm jacks and may try this method using a 2x4x8 or 10 to spread the load out along the underside of the camper top. The thing that confuses me, though, is at what point in jacking it up would the cables take the load? If the system is maxed at top position...
  9. pcorbin

    How to get guide block to "down" position

    Hello and thanks! So are you thinking I need to jack up the top to the up position?
  10. pcorbin

    How to get guide block to "down" position

    OK - I did this wrong, so am now looking to correct the mistake: This is for a 1997 187TD TowLite. I installed (4) new lift cables, with the camper top in the down position (resting on 3.5" boards laid on the frame rails front and rear - followed Rob from J&R's recommendation.). So far, so...
  11. pcorbin

    Anyone tried rebuild of frame rails only?

    We have a 1997 187TD. We've only had it for a few months, so I'm still getting things squared away so it can be used more often. We've camped in it twice, but during the second use, we had a cable snap. I'd looked at the cables before and saw no rust or fraying, but at the time had not seen the...

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top