Hyd pump/battery cover

[Fin reaper]

Hi, I'm looking for the plastic hyd pump/battery cover for my 1990 18' hi-lo. Any ideas where I may find one? Thx!

 

[JackandJanet]

Welcome, Fin - the later HiLos covered this area with a diamond plate metal sheet I believe, so it may be VERY hard to find that part in plastic. I would think you could make a cover out of a metal sheet you can find at a home improvement store such as Home Depot or ACE though.

- Jack

 

[Garry-HILO]

Hi, I'm looking for the plastic hyd pump/battery cover for my 1990 18' hi-lo. Any ideas where I may find one? Thx!

When we had our 21T I made a new cover out of sheet metal, but I shaped it so it lapped over the edge of the A-frame of the trailer and then attached tension release clamps to the cover and A-frame. The cover could then be removed when the top half of the trailer was in the lowered position, giving me access to the batteries and pump.

 

[cva34]

Mine looks like CPVC sheet...stock...it ain't cheap but its on ebay..play there game and ya might get a deal on it....

 

[campthewestcoast]

When we had our 21T I made a new cover out of sheet metal, but I shaped it so it lapped over the edge of the A-frame of the trailer and then attached tension release clamps to the cover and A-frame. The cover could then be removed when the top half of the trailer was in the lowered position, giving me access to the batteries and pump.

I did as you did with the lid, then built a full box with lid when I switched to 2 6 volt batteries when I had my older hi lo
Garry send me a PM I'm trying to figure out how I can make it to the 2019 rally in June

 

[Garry-HILO]

I did as you did with the lid, then built a full box with lid when I switched to 2 6 volt batteries when I had my older hi lo
Garry send me a PM I'm trying to figure out how I can make it to the 2019 rally in June

Hope you can make it in June, We will make reservations again and hopefully we will make the rally. Plan on being in Texas and leaving from there for the rally.