Search results

this camper has sold

For sale: 2310 HILO. Asking $6,000. Needs a little work. Front of camper on door side needs a doubler installed where the lift cable connects to the top, the awning is torn, and should be replaced, the day/night shade in the bathroom needs to be restrung, and the inside of the top section of...

Found the problem. The DC kill switch was turned off earlier while cleaning the camper.

No DC power in camper to lights and fans. Checked fuses to all the lights and checked the 30 amp fuse all checked good. AC power is working fine. what should I check next.

Thanks for the link Jack and Janet. Looks to me that someone before me attempted this repair. The bulb seal is touching the bottom of the contact rail on the bad corner, and maybe to high all around the trailer elsewhere. suspect they all may need to be lowered some. Will use a farm jack to...

My 2310H is bending where the cable attaches into the top of the camper on the front corner entry side. this causing that corner to drop a little. Do not think tightening the cable alone is a good fix. Need to do something to fixed the surface where the cable connects to the top. Any ideas or...

Thank you the solar model looks just like what I was looking for.

Thinking about getting a tire pressure monitoring system. Does anybody have any recommendations on which ones I should consider. Would like it to be wireless, monitor both tire pressure, and temp, and would continually update to my tow vehicle as I am going down the road.

Thank you for this information. The spring rods appears to work great. The length I purchased was 18 to 21 inches long. Smallest the had. Think I will remove the hing housing to give a better fit.

Thinking about getting a generator, so I can boondock. Looking for a bumper cargo carrier. Any suggestions will be appreciated. Thank you.

Check this web site: Custom Made Dinette And Gaucho Cushions For RVs And Trailers

Does anyone know what the cable lengths are for a 2310H

Just downloaded the Tool Box App. The level works great. Thank you for pointing out the App.:)

Thank you for your reply. Make sense to me. Checked cables this morning to see, if they were ok. All checked fine. Appears that that cable has been shorten before. Will wait until I lower before I attempt to tighten cable, if there is any slack.

We are fulltimers who have been stuck in one location for awhile. Yesterday, I noticed that one side has dropped a little on the front corner, and I cannot get the supports I made for heavy snow loads back in place. Any suggestion on what if anything should be done?

The adding of ATF to the reservoir was a good idea and a good to know if there is problem with the lift system. Thank you.

Just replaced the vent fan with a Vortex 2 fan which has 3 speeds forward and 2 speeds reverse. This was a fairly simple change out. 1) Had to drill out the rivets which held the old fan in. 2) Had to move the gear drive on the new fan to the alternate position, so I would be able to operate...