seal

Does anybody have a DIY for replacing cable seals? 3 of the 4 have fallen off and the last one is dangling on the cable. They look like pieces of rubber like a thick bike tube tire. Thanks!

Need some guidance on finding replacement seals for my slide out. Currently i have H-Column seal having a hard time finding the correct seal to replace this. I have went to my rv dealer and even gave them my Vin# for my 5th wheel. Does this still exist or is there a new replacement that is out...

So, while I was inspecting my TT roof today and giving the camper a general outside inspection, I noticed that a small amount of roof sealant has peeled away and the both drivers side and passenger side front seals have developed cracks. I can replace both seals with product from Camping World...

What should I use to seal these cracks in the roof sealant around this skylight? Also what's the best way to use it?

Was out at my 2019 FR3 33DS about two weeks ago and found that my toilet seal was missing. My DW and I think that when we were cleaning the RV after our last trip, she may have brushed the opening too hard and the toilet seal went down the drain into our black tank. I went to the RV today to...

While investigating a leak today, I found that several of the screws under the rubber 'strip' that is part of the rain gutter were installed crooked, leaving gaps between one side of the screw head and the hole behind it. Any water that gets to the space between the rubber strip and the...

Anyone have a substitute for a seal if you go to a rv park and it is mandatory and you cant get one. Hopfully make one that will satisfy the parks regulations.

I found out last night during a thunderstorm that the skylight above my shower has several spots that has spiderweb cracks and is leaking. I have a can of paint on FlexSeal could I use this instead or replacing the skylight itself?

Hi I have the Apex Nano 193 BHS 2019. It's off of warranty May 2nd. The issue has been reported and noted but my service center is closed due to the virus. I also reported a thump in another thread. My slide side seal has a rip that's been reported. I'm just wondering ..if I had to do the work...

This 2017 Forester was purchased used and the former owner, it appears,did zero or slightly less maintenance. The bunk (curb side) slide out top gap for is about 3/4 of an inch, where as the street side slide out (couch) has close to 1 1/2 inches. The small gap does not permit the top "sweep"...

Have a 2018 Cardinal 3920. What type roof do I have? Rubber? Do I clean and seal? Best product to use? Thanks for your time to comment!!!

Climbed up on my 192 this week. Everything looked good. One question: I notice there was no Dicor inside the clips around my fan vent. Seems like this would be an entry point for water, especially under snowpack. Should I add a little Dicor in there, or will that muck up something else...

Not sure what to do in the back two corners of my Surveyor 24 sport with the 2001 flat roof. The two corners have a bad design to trap water, I tilt the camper to the left rear corner when camping but I’m limited to how much so I don’t effect sink and shower drains. This is how it was...

Hi! I have a Rockwood Premier pop-up. It is vinyl on canvas. What is the best way and product recommendation to seal the seams?

I checked out my trailer this weekend (what else is there to do) and noticed that the caulking (Dicor) on the roof is showing signs of minor cracking. The trailer is a 2012 with original seams and Dicor. Can I apply self-levelling Dicor directly over the existing or does the existing have...

I just finished applying the full POR15 treatment plus topcoat to my 22-year old dual axle steel boat trailer, which has been stowed outdoors in Florida for the past 16 years. I had to have the three main steel cross pieces that support the boat bunks replaced with new steel due to excessive...

I'm looking to perform a little PM on my front cap seam with the roof and other spots on the roof. The roof looks in good shape but based on postings here this sounds like a good PM activity. I'm thinking of going with the EnternaBond RoofSeal Plus for the cap seam since this material is...

I read somewhere that you should use a conditioner or protectant on your slide seals. Just wondering what to use.

Our 5’er is now a seasonal. I would like to seal up the hitch under the front cap to keep critters out. The plastic under panel has, understandably gaps around the hitch and the hitch itself is open. With all the irregular shapes and angles my poor little 15 watt grey matter has struggled and...

I discovered quite by chance that a D seal in the wardrobe slide out has come loose. Accessing it will be difficult at best. My thought is to remove the trim from the front. This *should* allow me better access to remove the old and install the new. Since I have no experience with this I want...

We picked up our new Flagstaff Micro Lite 25 RKS the last week of February. The PDI went well and the dealer immediately fixed a few minor issues we found. After getting it home, I spotted a small area on the roof that didn’t look right from our upstairs window. A close up inspection showed a...

2018 Geo Pro 19FBS - This weekend I noticed a small gap beginning to form in the corner of my slide out's seal. Despite the pics this gap is on the top corner of the slide out. I was told by the dealership this is NOT a warrantied repair and is considered a maintenance issue. Is there a...

So I’m brand new to hybrid ownership. What should I use for maintenance on the seals and fold outs? Also how often? Experience trumps research so I would really appreciate you guys that have lived it letting me know what works best.

What are most people using when sealing outside fittings (like power outlet, tail lights, water fittings, antenna fitting)? I know Dicor is the favorite for roof fittings but that’s not what the factory used on outside fittings. It looks like they used some brand of clear sealant/caulk.

Is there a product for EPDM roofs that can be tinted instead of the bright white? Our unit is the light bronze fiberglass sides and white would be harsh where the rubber comes down over the sides of the roof..... Also wondering if Henrys TropicCool is comparable to the Liquid Roof product...