slide out

My 2019 Georgetown 36B5 main slide out squeeks loudly on final 2” when retracting. The noise is coming from where the motor engages on the tooth strip. I sprayed silicone spray on it and it is much better. Is there a more lasting lube I can use such as a light grease? It was bone dry while it...

Hi everybody! I have a 2020 Epro E20BHS and the slide doesn’t work. Could any of you help me find the “FUSE” or “CIRCUIT BREAKER” for it ? I cannot find it. Troubleshooting: Long story short, I have no power to the red wire at the “box”. The red wire goes in the wall and disappear. I...

Looking for ideas for protecting underneath my slide outs… I would think almost anything would be an improvement to the woven plastic…. what about tearing all that off and using resin and fiberglass cloth ? it works for boats to keep water out and will also make the floor stronger with not much...

I have a 2004 Forest River Wildwood 38 FBRB LTD park model. When I tried to bring slides in they don't budge. I looked and the battery was 12 years old so replaced it. I am also hooked up to shore power. I checked the two fuses in the panel and they look good. I can't seem to find any way to...

Left for camping trip in 2018 Columbus and all slides worked fine to retract. On arrival the slideout w recliners wouldn’t go out. Manually extended. Then it seemed to just work and was able to retract. Got it home and wouldn’t go out again. Started manually putting out and then retested and it...

We have a 2015 hideout and the slide out light are not working. looking for junction boxes to no avail. any answers?

I have a 2004 fifth wheel model 281EFS. The slide out extends extremely slow and won't retract without pushing from the outside to get it started.

Hi, we just purchased a 2018 Georgetown 30x3 and are wondering if it's safe to extend the slides without leveling the motorhome - our driveway is on a bit of an incline. Or should you always level first and then extend the slides? Thanks for our help!

My back slide out is for my closet only on driver side. It starts to open and then one side stops while the other keeps going. I was able to push on the side that binds so at least. I can make the bed. Gonna see what happens when I try to get it in. I’m not that tall to push in the middle. Is...

Hi. First time poster, long time reader. In my 2021 3051S, my slide is going about 4 inches. Stops. Push extend and another 4" and stops. Repeat. Same on retract. I had been chasing an electrical gremlin for a couple years that I finally figured out after a new converter, a new set of lead acid...

I made a classic mistake not long ago, I opened the big slide (with the lippert) only part way, then slide it back in. Since then, I have to manually turn the slide out crank barely 1/4 inch and then I can open the slide out normally, and pull it in normally. It makes some funny sounds at...

I'm new to this travel trailer world. I bought a 2021 keystone Hideout with 3 slides and I'm freaking out because suddenly all of them have bubbles now. I've been told it could be heat to water damage. I've been told to always run a dehumidifier since I'm currently living in it. I wish honestly...

So a small section of the slide out awning on our 30FW (the edge along the roofline of the RV) came out of the "groove". ti is about 3" near the leading edge. What is the correct way to slide it back in? Assuming i will have to remove or disconnect the roller side, slide it forward to the...

Looking to see if somebody can assist with information on the location of the slide out motor on a 2019 Alpha Wolf DBH-L. Also would like to know where you can manually operate the slide out. Thanks for any assistance anyone can provide.

Just returned from 2-1/2 week trip out west in our new to us 2022 31L5 Georgetown. Everything was going great until the last couple of days when the large slide out was not closing properly. It’s like it somehow got shifted so it closes at a little bit of an angle where the front edge(just...

I have a 2015 Thor Palazzo 37 ft. The slideout stopped working this morning when the large slide was almost all the way in. I tried to bring the bedroom slide in but it didn't budge and seemed like it was not getting power. After I checked what I am aware of, I had to call a Mobile RV repair...

Has anyone encountered this setup on their slide out? Aluminum "T" stops, attached with self tapping metal screws.

I have a 2021 Forest River Evo with schwintek slide, just the other day when we arrived at our campsite the slide would move about 5 inches and get stuck. It seems like the side towards the front of the trailer moves ok, but the side towards the rear of the trailer is binding. After working back...

2023 Isata 5 28SS Just got my coach back from the dealer for slide failures repair. They replaced the front motor and controller. I noticed at least one screw missing in the interior and 3 are loose striped out on the exterior holding the trim in place. What is the process to use the next...

Anyone tell me how to get a Sunseeker 3050S full wall Schwintek slide to retract? It went out fine but the motors do nothing when I try to bring it in. If I push the Out button, I can hear both motors attempt to work even though the slide out is fully extended now.

Hello I have a forest river evo bunkhouse with a duel motor shwintek slides out, for some reason the rear lower gear skipped a tooth and was out of alignment with the top. When trying to use the slide the dinette which is at the rear hits the ground gets jammed and stops moving. I have since...

Have 2021 Jayce Eagle HT 27 RS, have the cable and chain slide drive. Motors run but the gears are not turning to drive the sprocket.is there a key in there on that sprocket? Anyone have a parts break down? Do those motors just come out the top? If nothing else I need to find the procedure to...

Hello - I was so busy with work that I did not have time to test things out on our Grey Wolf 2020 19SM before we take it out on our first trip of the season tomorrow. I went to slide out the rear bed and one side proceeded to extend and one side didn't. I wasn't watching when that happened and...

We are having issues with our slide out... and believe that out slide out's topper to be a cause of our issues. It stops on one side when extending. The drivers side front seems to bind up and stop the slide. We've had a lot of frustration with the slide and are considering removing the slide...

Just wondering if people here support their slide outs? If so, what kind of parameters(size, weight,how far it slides) do you use to determine to support or not. Thanks for the help… [/S]